![]() The discussion is kind of stuck since Sep. MinimServer: startup error (see crash file for stack trace) MinimServer: ohNet port 9791 is already in use All rights reserved.ĪutoUpdate: installed package 'minimserver-0.8-update-104' This should start MinimServer in a Docker container. In a terminal window, change directory to this folder and run the following commands:ĭocker run -p:1900:1900/udp -p:9790:9790 -p:9791:9791 -net=host minimserver:0.8.4.7 ![]() I followed these steps as provided by Simon:Ĭreate a folder to be used for building the Docker image (I used /mnt/user/system/docker/appdata/minimserver)ĭownload the file MinimServer-0.8.4. from this page and save it in this folderĭownload the file Dockerfile.bin from this link, save it in this folder and rename it to Dockerfile Good morning sonofdbn, here is a discussion that you might find useful: Is something else required in order to enable UPnP? (And is that the likely problem?) So I think I misunderstood what is required. It was suggested there that Bridge mode should be used for Network Type, so I tried that, but it seems to remove (or not require) any port mapping then. I read a thread here on the Logitech Media Server docker which mentioned a similar-sounding UPnP problem. I'm wondering if the problem is with UPnP (which I know very little about) and whether it somehow needs to be enabled on unRAID. (I tried shutting down the Syno server and reinstalled MinimWatch, but that didn't help.) But I couldn't get it to find the docker MinimServer. I installed it, and it had no problem finding a MinimServer test server that I was running on a Synology NAS. MinimServer is controlled via MinimWatch, which can be installed on a Windows PC. The problem was that I couldn't access it from any PC on my network. It required going to MinimServer's http page and accepting a licence agreement, but after that it seemed to be OK, as its web ui said it was running (and the log showed this as well). ![]() Somewhat to my surprise (and a testimony to the amount of information available here), I managed to get MinimServer running. I haven't done a "manual" docker install before, but after a bit of reading I managed to download it via the CA tab and fiddled around mapping paths and ports, and in particular setting Network Type to "Bridge". MinimServer is a UPnP music server I'm trying to install a MinimServer docker ( ). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |